Examples
Examples
Try the starting example
- Finished face width (cm)
- 30
- Finished height (cm)
- 35
- Finished depth (cm)
- 10
- Seam allowance (cm)
- 1
- Top turn-down allowance per panel (cm)
- 3
- Finished handle length (cm)
- 50
- Finished handle width (cm)
- 3
- Body panel width, cut 2 (cm)
- 42
- Body panel height, cut 2 (cm)
- 44
- Box corner cutout side (cm)
- 5
- Fourfold handle strip width, cut 2 (cm)
- 12
- Handle strip length, cut 2 (cm)
- 52
Try another scenario
- Finished face width (cm)
- 40
- Finished height (cm)
- 35
- Finished depth (cm)
- 10
- Seam allowance (cm)
- 1
- Top turn-down allowance per panel (cm)
- 3
- Finished handle length (cm)
- 60
- Finished handle width (cm)
- 3
- Body panel width, cut 2 (cm)
- 52
- Body panel height, cut 2 (cm)
- 44
- Box corner cutout side (cm)
- 5
- Fourfold handle strip width, cut 2 (cm)
- 12
- Handle strip length, cut 2 (cm)
- 62
Calculation method
Calculation method
Body panel width, cut 2 (cm)
W+D+2s.
Body panel height, cut 2 (cm)
H+D/2+s+topTurn.
Box corner cutout side (cm)
D/2 from raw lower corner.
Fourfold handle strip width, cut 2 (cm)
4*finishedHandleWidth; edges folded to center then in half.
Handle strip length, cut 2 (cm)
finishedLength+2s; s is attachment allowance at each end.
Symbols and units
- a
- Finished face width (cm)
- b
- Finished height (cm)
- c
- Finished depth (cm)
- d
- Seam allowance (cm)
- e
- Top turn-down allowance per panel (cm)
- f
- Finished handle length (cm)
- g
- Finished handle width (cm)
Use the units shown. A list keeps the order in which you enter its values. The symbol ^ means “raised to the power of”.
Assumptions & limits
Assumptions & limits
- Unlined boxed tote, raw-edge corner cutout convention and fourfold handles. Attachment, interfacing, reinforcement and load capacity are outside this geometry worksheet. Supported limits: All finished dimensions>0; seam and turn-down>=0.
Are these inputs private?
These calculations run in your browser. A shared link contains the values you choose to share. Only questions submitted to the separate AI finder are sent to OpenAI.